DCT (Dual Coil Tank) 3.5ML & 6ML Combi-pack. Try  one of each size! Only £24.99

Be dazzled at the stunning look of this Dual Coil 510 XL 1.5 ohm Tank Cartomizer. With brilliant polished chrome end pieces and a polished chrome drip tip.

The tank tubing is made from polypropylene* in 8 fantastic colours and comes supplied with a dedicated cartomiser and drip tip.

6ml Dimensions (without cartomiser and tip) 44mm (L) x 20mm (D)
3.5ml Dimensions (without cartomiser and tip) 44mm (L) x 15mm (D)

*Polypropylene is considered more stable with different e-liquids than the polycarbonate tubes

Filling Guide:

It is important to remember when priming a new unused DCT cartomizer for the first time that you take your time to ensure the e-liquid is soaked well into the filler material. Each DCT kit will contain 1 silicone seal which is used after the cartomizer primed.



1. Remove the aluminum drip tip.



2. Holding the whole DCT at an angle drip e-liquid onto the sidewall rotating the cartomizer as you do so. Continue to drip liquid into the cartomizer until the liquid just sits on top of the wadding and wont take any more e-liquid, this can take up to 5 minutes.

3. Avoid allowing the e-liquid to enter the central core of the cartomizer as the e-liqiud will travel down the central tube and drip out of the bottom.

3. After priming the cartomizer, withdraw the cartomizer a short way from the tank, tilt the artomizer at a slight angle and drip the liquid down the wall of the tank, when the tank is filled sufficiently, push the cartomizer back into position taking care not to damage the ‘O’ ring in the top.

4. Insert the provided silicone seal* flat side up into the cartomizer, replace the drip tip and your DCT is fully primed and ready to be fitted to the battery. 



5. After fitting to the battery, take 2 cold priming vapes without pressing the power button, this is to get the air circulating, after this the DCT will be ready to vape.

Further fillings of a previously filled cartomizer will not require the initial priming procedure. *Addendum: The supplied instructions have not included the use of the silicone seals provided, this is an error, and they should be placed into the cartomizer flat side up to prevent the wadding material drying out. Please refer to the filling instruction video above.


Warranty

The Dual Coil Tank which includes the Polypropylene Tube and End Caps comes with a 28 day parts replacement warranty. Although made to the highest quality,  devices may fail or degrade over a period of time, especially if in constant use.

Please be aware that the Cartomizer is sold with a DOA warranty only, although it can be refilled many times.